Home / Knowledge / Indoor wet rooms Aqua 2K on kitchens and showers
Indoor wet rooms Aqua 2K on kitchens and showers
Engineer notes. Not a blog. Indoor wet rooms Aqua 2K are a solvent-free cold lining. They are not a chlorinated pool and not a roof 1K.
Schedule indoor wet rooms Aqua 2K as a cold, solvent-free lining. Catalogue 2024 writes solvent-free polyurethane and polyurea resins for kitchens, bathrooms and showers. Impermax Aqua 2K (solvent-free two-component polyurethane) is totally stable in contact with water, even when submerged. The waterproofing catalogue names indoor wet rooms in the Middle East at 80–100 m². Therefore the specifier writes commercial name and chemical type in the same sentence.
What indoor wet rooms Aqua 2K actually allow
Coverings may be exposed with a solvent-free protective finish or protected with tiling. Impertrans Eco (water-borne aliphatic polyurethane topcoat) is the finish Catalogue 2024 pairs with solventless membranes. Impermax Evolution (low-odour hybrid moisture-activated polyurethane) is the 1K the indoor page also names. Porosity Sealer Flex (flexible polyurethane porosity sealer) is the primer on that schedule. Do not swap Primer Epoxy 100 onto this card unless the current sheet says so.
However, a shower is not a swimming pool. Paintchlore 2K stays on chlorinated immersion. WRAS stays on drinking-water tanks. Also, do not invent kg/m². Read mix, overcoat and consumption from the current TDS, then the calculator.
How to write indoor wet rooms Aqua 2K
First, name the kitchen, bathroom or shower as indoor. Then name Impermax Aqua 2K (solvent-free two-component polyurethane) or Impermax Evolution as the catalogue lists them. After that, name the solvent-free finish or the tiling. In addition, size the area on the calculator once the sheet is read.
See Impermax Aqua 2K, Impermax Aqua, Impertrans Eco, indoor wet rooms and documents. Area is sized on the calculator.
Outbound reference: CEN-CENELEC — EN 1504-2.
A tiled wet room is not a cool roof. Keep indoor wet rooms Aqua 2K on the solvent-free names.
Therefore the current TDS remains the source for consumption. A number invented here would be a specification error.
These notes do not replace the current TDS, SDS or a written specification. For pack sizes, mix ratio and kg/m², read the current sheet, then the calculator.