Home / Knowledge / ProLine coatings for oil and gas containment
ProLine coatings for oil and gas containment

Oil and gas protective coatings from Krypton Chemical belong to the Krypton ProLine range (industrial protective coatings for oil and gas, marine and ports). The 2026 catalogue covers refinery plants, crude oil storage tanks, and primary and secondary containment, which is a very different field from roofing.
ProLine coatings for oil and gas
Abrasion and impact: Krypton ProLine AB95P and ProLine AB85H. Chemical attack: Krypton ProLine CH55 and ProLine CH80. Epoxy abrasion: Krypton ProLine MFE 100. Epoxy chemical: Krypton ProLine NE 500. Polyurethane primers: Krypton ProLine PU ZN Primer and PU AL Primer. Intermediate: Krypton ProLine AC MIO. Top coats: Krypton ProLine Silver TC and PU 1000TC.
The industrial catalogue also lists leak protection and seamless single-layer application. Check the current TDS, then calculate the quantities with the calculator.
ETA 06/0263 belongs to Impermax, not to ProLine. Those certifications apply to named waterproofing membranes, while oil and gas protective coatings remain within the ProLine range.
Specifying containment
Start from the exposure (abrasion, chemical attack or corrosion), then choose the ProLine product and check the current documents.
Further details are on the oil and gas petrochemical and liquid containment application pages and the ProLine AB95P product entry, with data sheets in documents.
External reference: CEN-CENELEC.
A roofing ETA does not qualify a product as a tank lining. Use ProLine products for containment and Impermax products for roofs.
Mix ratio, overcoat interval and consumption always come from the current TDS, and the calculator then turns them into quantities for your area. The application page shows the full system build-up. A sound specification starts with the exposure, names the commercial product together with its chemical type, and refers to the current documents. A sample, a colour chip or a photograph cannot replace that wording. The finish belongs in the same clause as the membrane body.
This article is general technical guidance from Krypton Chemical and does not replace the current technical data sheet (TDS), the safety data sheet (SDS) or the project specification. Pack sizes, mix ratio and consumption in kg/m² are given in the current TDS; with those figures, the calculator helps you estimate quantities for your area.
