Home / Knowledge / Cerceda footbridge coated with Rayforce and Top G 2K
Cerceda footbridge coated with Rayforce and Top G 2K

A metal footbridge in Cerceda (Madrid), coated with Rayforce (surface-tolerant epoxy mastic) and Rayston Top G 2K (two-component polyurethane topcoat).
Rayforce (surface-tolerant epoxy mastic) was the primer on the metal footbridge in Cerceda (Madrid), followed by Rayston Top G 2K RAL 7022 (two-component polyurethane topcoat). Both names, Rayston Rayforce mastic red and Rayston Top G 2K, come from magazine No. 2 and are not current catalogue products. Read them as a surface-tolerant epoxy mastic and a 2K PU finish, and check the current TDS.
How the Cerceda footbridge was coated
The existing paint system was unknown, and rust was concentrated on the lower members, possibly from winter de-icing salts. According to the magazine, every corrosion point was mechanically brushed to ST3, then coated with Rayston Rayforce mastic red at 140 µm and Rayston Top G 2K RAL 7022 at 100 µm. These micrometre values are the dry-film thicknesses reported in the magazine, not consumption rates. The pedestrian deck received a separate Rayston flooring system.
Consumption is given in the current TDS; the calculator then helps you estimate quantities.
More on this application is on the metal structures application page and in the products section, with data sheets in documents.
External reference: ISO 12944-2 — corrosivity categories.
For similar steelwork, specify ST3 preparation, the epoxy mastic and the 2K PU finish, and treat the pedestrian deck as a separate system.
This article is general technical guidance from Krypton Chemical and does not replace the current technical data sheet (TDS), the safety data sheet (SDS) or the project specification. Pack sizes, mix ratio and consumption in kg/m² are given in the current TDS; with those figures, the calculator helps you estimate quantities for your area.
