Home / Knowledge / WRAS-approved lining for drinking-water reservoirs
WRAS-approved lining for drinking-water reservoirs

The 2026 Krypton Chemical catalogue specifies Polyurea Rayston (pure polyurea) as the membrane for drinking-water reservoirs. The system holds WRAS approval to BS6920, together with CE marking to EN-1504-2, ETA ETAG005 16/0148 and BBA 18/5582. A one-component (1K) roof coating is therefore not a suitable reservoir lining.
Polyurea Rayston: the drinking-water lining
Polyurea Rayston is used for drinking-water tanks and for wastewater treatment plants. It is a 100% pure polyurea applied by hot spray. Where the coating is exposed to UV, a protective topcoat is required. Impermax Aqua 2K is a different product, a water-retaining polyurethane, and does not carry the WRAS approval.
Reservoirs, drinking-water tanks and related hydraulic works are covered on the applications page. The right primer depends on the substrate on site and is given in the current TDS; the calculator then helps you size the area.
Specification and documents
Full details are on the drinking-water reservoirs application page and the Polyurea Rayston product entry. Data sheets and certificates are in documents, and the calculator helps you estimate quantities.
External reference: WRAS Approvals.
Roof coatings are not intended for contact with drinking water, so a reservoir specification should name the WRAS-approved Polyurea Rayston.
Mix ratio, overcoat interval and consumption always come from the current TDS, and the calculator then turns them into quantities for your area. The application page shows the full system build-up. A sound specification starts with the exposure, names the commercial product together with its chemical type, and refers to the current documents. A sample, a colour chip or a photograph cannot replace that wording.
This article is general technical guidance from Krypton Chemical and does not replace the current technical data sheet (TDS), the safety data sheet (SDS) or the project specification. Pack sizes, mix ratio and consumption in kg/m² are given in the current TDS; with those figures, the calculator helps you estimate quantities for your area.
