Tordera railway bridge waterproofed with Impermax Polyurea H Flex

Home / Knowledge / Tordera railway bridge waterproofed with Impermax Polyurea H Flex

Tordera railway bridge waterproofed with Impermax Polyurea H Flex

Aerial of the Tordera railway bridge deck with workers in yellow vests, hoses and a bucket on the concrete, river below

A railway bridge over the Tordera was waterproofed with Impermax Polyurea H Flex, a hot-spray hybrid polyurea membrane.

Rayston Epoxy 100 (solvent-free epoxy primer) was used as the primer, and a geotextile protects the membrane before the ballast is laid. The ballast itself is not part of the waterproofing.

01

How the deck was built up

The structural deck was prepared with Rayston Epoxy 100 (solvent-free epoxy primer). Impermax Polyurea H Flex (hot-spray hybrid polyurea), which Catalogue 2026 lists for bridge and viaduct decks, was then applied as a continuous elastomeric layer; the project record gives its crack-bridging class as B.4.2 dynamic / A5 static.

A geotextile was then bonded over the membrane, and the railway ballast was laid on top as the track base. The polyurea must not be left as the wearing surface under the ballast. For consumption, read the current data sheet, then use the calculator.

02

Specifying Impermax Polyurea H Flex for a railway deck

List the primer, the hot-spray hybrid polyurea, the geotextile and the ballast as separate items. Photographs of the spraying do not replace the protection clause.

See also bridge decks, viaduct decks and products. Data sheets are in Documents.

Project page: kryptonchemical.com — railway bridge over the Tordera.

Outbound reference: EOTA.

B.4.2 / A5 is the class given in the project record. Confirm it on the current data sheet before the specification is finalised.

This article does not replace the current TDS, SDS or a written specification. Pack sizes, mix ratio and consumption in kg/m² are given on the current data sheet; use the calculator to work out quantities for your area.

Scroll to Top