Pure polyurea vs hybrid on roofs

Home / Knowledge / Pure polyurea vs hybrid on roofs

Pure polyurea vs hybrid on roofs

Roof waterproofing system layers

Polyurea Rayston (pure polyurea) is the pure hot-spray system; Impermax Polyurea H (hot-spray hybrid polyurea) is the hybrid.

01

Certifications that distinguish pure polyurea from hybrid

In the 2026 Krypton Chemical catalogue, Polyurea Rayston carries CE EN-1504-2, ETA ETAG005 16/0148, BBA 18/5582 and WRAS. Impermax Polyurea H carries ETA 11/062. Impermax Polyurea H Flex carries EAD-030675 21/0740 for bridge decks. Impermax Polyurea H Supreme and Impermax Cold Polyurea Supreme carry CE EN-1504-2.

Airport roofs, car-park roofs and pedestrian roofs may use more than one of these systems; the application page shows the full build-up. Cold polyurea (ETE 17/0509) is a third family: it is not hot-sprayed and it is not Impermax 1K. Always use the exact product name shown in the catalogue.

A UV finish is still required where the catalogue calls for it. Rayston Fire E is a membrane for stadium bleachers, not a general-purpose roof finish. Take consumption from the current TDS, then use the calculator.

02

Naming the two systems correctly

For each product, quote only the certifications that the 2026 catalogue lists for that name.

Details are on the Polyurea Rayston and Impermax Polyurea H product entries and on the airport roofs application page.

External reference: BBA — British Board of Agrément.

A generic "polyurea" note on a drawing is not enough: name the product and its chemistry.

Mix ratio, overcoat interval and consumption always come from the current TDS, and the calculator then turns them into quantities for your area. The application page shows the full system build-up. A sound specification starts with the exposure, names the commercial product together with its chemical type, and refers to the current documents. A sample, a colour chip or a photograph cannot replace that wording.

This article is general technical guidance from Krypton Chemical and does not replace the current technical data sheet (TDS), the safety data sheet (SDS) or the project specification. Pack sizes, mix ratio and consumption in kg/m² are given in the current TDS; with those figures, the calculator helps you estimate quantities for your area.

Scroll to Top