Green roofs specified as a system

Home / Knowledge / Green roofs specified as a system

Green roofs specified as a system

Green roof planting strip with drip irrigation beside a galvanized HVAC duct and glass skylights

A green roof combines a waterproofed roof, a root barrier and a drainage build-up. The 2026 Krypton Chemical catalogue identifies the membrane that carries ETA 11/062; the planting layers themselves are not a Krypton membrane.

01

Why a green roof needs a named membrane

Impermax Polyurea H (hot-spray hybrid polyurea) is the hot-spray hybrid intended for roofs and green roofs, with ETA 11/062, and the 2026 catalogue also marks it for resistance to root penetration. Impermax B 1K (one-component polyurethane-bitumen) is the root-resistant bitumen-polyurethane the catalogue recommends for details and foundations. Impermax 2K also lists green roofs among its uses.

The gardened roofs application page sets out the complete build-up: primer, membrane, finish and the related documents. No consumption rate is given here for the planting build-up.

If the roof is not planted, use the pedestrian or industrial roof application instead. In either case, take consumption from the current TDS and then use the calculator.

Rooftop green-roof planting bed with drip lines, young plants, and in-soil spotlights
02

Even when the green roof is treated as a complete system, the current data sheet remains the reference for each product.

You will find more on the gardened roofs application page and the Impermax Polyurea H product entry, with data sheets and certificates in documents.

External reference: EOTA.

The ETA 11/062 assessment belongs to the named membrane, not to the planting build-up above it.

Mix ratio, overcoat interval and consumption always come from the current TDS, and the calculator then turns them into quantities for your area. The application page shows the full system build-up. A sound specification starts with the exposure, names the commercial product together with its chemical type, and refers to the current documents. A sample, a colour chip or a photograph cannot replace that wording.

This article is general technical guidance from Krypton Chemical and does not replace the current technical data sheet (TDS), the safety data sheet (SDS) or the project specification. Pack sizes, mix ratio and consumption in kg/m² are given in the current TDS; with those figures, the calculator helps you estimate quantities for your area.

Scroll to Top