Inicio / Conocimiento / Punto de rocío, humedad residual, intervalo de repintado
Punto de rocío, humedad residual, intervalo de repintado
Notas de ingeniería. No un blog. Hold the coat until dew point residual moisture and air match the method on the TDS. Weather apps are not an application window. Therefore the shift waits on measured values.
Dew point residual moisture on concrete
Residual moisture in concrete is why Catalogue 2024 lists Humidity Imprimación and Humidity Imprimación LV. Those are epoxi imprimacións for residual moisture, not standing water. Imprimación Epoxi 100 is a different epoxi imprimación. Do not swap the names.
The overcoat interval belongs to the membrana nominada and its finish. Colodur Eco (aliphatic finish), Floortop 1K and the ProLine top coats each have their own window on the current sheet. Splitting a 2K kit is not an interval. Rolling another thin film over a blister is not an interval either.
However, this note does not print those numbers. Read them from the current TDS, then the calculadora if the area is known. In addition, keep mix ratio on the sheet.
What the specifier writes
First, write the dew point residual moisture limit from the TDS. Then write the overcoat window for the finish. After that, name Imprimación Epoxi 100 or Humidity Imprimación as the catalogue actually lists them.
See Humidity Imprimación, Imprimación Epoxi 100, documentos, and the calculadora.
Outbound reference: EOTA.
A shift that ignores dew point residual moisture will write a blister into the next coat. Keep the numbers on the current sheet.
Therefore the current TDS remains the source for mix ratio, overcoat and consumo. Then the calculadora sizes the area. However, a number invented here would be a specification error. In addition, the application page is the schedule. First name the exposición. Next name the commercial product and the chemical type in the same sentence. After that, open documentos. Also keep the finish on the same clause as the body. A sample, a colour or a photograph does not replace that sentence.
These notes do not replace the current TDS, SDS or a written specification. For pack sizes, mix ratio and kg/m², read the current sheet, then the calculadora.