Home → Applications → Swimming pools
Swimming pools
Swimming pools require a continuous water-retaining lining matched to chlorinated immersion, pool-shell geometry, wet detailing and maintenance regimes. This engineering guide frames the application intent without replacing the current system specification or product technical data sheet.
DATA SHEET · Rayston Epoxy 100
DATA SHEET · Polyurea Rayston A
DATA SHEET · Paintchlore
DATA SHEET · Paintchlore
Use and application
The application intent is waterproofing of swimming pools. Start by qualifying the substrate, exposure, service level and maintenance constraints. Rayston Epoxy 100, Polyurea Rayston A and Paintchlore are typical reference products for this application. Compare the current Products and Systems documentation, and use the associated application context at Waterparks to keep the scope distinct.
01
Chlorinated immersion and pool-shell detailing
Pool shells see permanent immersion, chlorination or other treatment chemicals, splash zones and wet–dry cycling at the waterline. Concrete shells bring porosity, cracking and moisture risk; finishes and tiling must not break membrane continuity. Floors, walls, steps, gutters, skimmers, lighting niches, pipe penetrations and expansion joints need a continuous, documented detail before the lining route is fixed.
02
Layers and references
Define the sequence from prepared substrate through primer or bond coat, functional membrane or body coat, reinforcement where specified, and protective or finish layer where required. Use the current technical data sheet for preparation, mixing, consumption, thickness, overcoat windows and cure; the Calculator supports quantities, while Systems and the product references establish the applicable route.
03
Common mistakes
- Ignoring chlorination and treatment chemistry when selecting lining and finish compatibility.
- Treating the pool floor as the whole waterproofing detail and omitting walls, steps, gutters, skimmers, niches or joint terminations.
- Closing the build-up before checking moisture, adhesion, thickness, pinholes and cure under immersion conditions.
04
Operating sequence
1. Record treatment chemistry, immersion duty, pool dimensions, substrate condition and service scenario. 2. Map joints, steps, gutters, skimmers, niches, penetrations and repair zones. 3. Select a compatible route in Systems and verify every layer against the current technical data sheet. 4. Calculate quantities with the Calculator. 5. Approve a representative area, document preparation and application controls, inspect continuity and release the pool only when the project requirements are met.